Make your own free website on Tripod.com
 



  Products News Documentation
User Group Downloads
Ordering+Pricing Testimonials About us


The PF1 cable must be as short as possible. Ours is about 8 inches long. One end is 1/4 stereo male, the other 9 pin male. Use shielded cable with at least 3 inner coductors plus the outer shield. There is a ferrite RF block around the cable close to the stereo plug end. You also need to install a ferrite block on your PDA serial cable as close as possible to the PDA/Cradle.
Stereo plug side                         9 pin side
-----------------------------------------------------------
tip                                      2
ring                                     3
ground                                   5

On the stereo plug side, the cable shield needs to be connected to the stereo plug ground. One the 9 pin connectro side, the cable shield needs to be connected to the connector shell.
Copyright © 2004 AtelierRobin. All rights reserved.
Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark.